HP-UX 11i v3 Installation and Update Guide, September 2007 (Update 1 Release)

Table A-1 Known Install and Update Problems (continued)
Description/ActionProblem
The HP Service Control Manager (HP SCM) is not supported on
HP-UX 11i v3. If your system is running SCM, you must migrate to
HP System Insight Manager (HP SIM) version 4.2 BEFORE updating
to HP-UX 11iv3; otherwise the update may fail.
What To Do
Remove HP SCM before updating to HP-UX 11iv3. If you are
updating your system to HP-UX 11i v3 and HP SCM is installed on
your current system and you do not want to run it in the future, you
must remove the HP SCM product before you update to HP-UX 11i
v3.
Uninstall HP Servicecontrol Manager using the following command:
swremove -x enforce_dependencies=false ID
where ID is the product or bundle ID as shown in the following
example syntax:
swremove -x enforce_dependencies=false B8339BA
Remove the old product sub-directories by executing the following
command: rm -fr /opt/mx /etc/opt/mx
You can also remove the database for Service Control Manager,
mysql, by executing the following command: swremove mysql
You may also choose to migrate HP SCM version 3.0 to HP SIM
version 4.2 before updating to HP-UX 11iv3. You must be running
HP SCM version 3.0 to perform this update. If you are running an
earlier version you will need to update HP SCM to version 3.0 before
updating to HP SIM version 4.2.
For more information on migrating from HP SCM to HP SIM version
4.2 please see the HP Systems Insight Manager 5.1 Installation and User
Guide.
HP Service Control Manager
(SCM) not supported on HP-UX
11i v3
122 Known Problems and Troubleshooting