HP-UX 11i v3 Installation and Update Guide, March 2009 (Update 4 Release)

Table A-1 Known Install and Update Problems (continued)
Description/ActionProblem
While updating from a previous OEUR to the HP-UX 11i v3
September 2008 OEUR and beyond, the following message may be
logged onto the console:
/sbin/rc[14]: /sbin/rc2.d/S700vxatd: not found.
What To Do
This is a harmless message. Installation is not affected. Veritas
Authentication Service (VRTSat) will start without any problem
once the update is complete.
Update from Previous OEUR to
HP-UX 11i v3 September 2008 and
Beyond May Log Harmless
Message on Console Regarding
VRTSat
While cold-installing HP WBEM Services, the SSL certificates are
generated with short host names. These certificates cannot be used
by the WBEM Service clients. The following warning message is
logged in the swagent.log file:
Note: Cannot find the fully-qualified domain name
(FQDN) for this system, SSL certificates for WBEM
Services are created with the short hostname.
Correct this either by editing the /etc/hosts file
or by making the appropriate DNS registration. If
not corrected, the created certificates may not be
acceptable to the WBEMService clients that expect
a FQDN in the common name field of the SSL
certificate. After the hostname(FQDN) is
configured, run /opt/wbem/sbin/gen_wbem_certs to
create SSL certificates for WBEMServices. The
existing certificates /etc/opt/hp/sslshare/cert.pem
and /etc/opt/hp/sslshare/file.pem will be moved to
/etc/opt/hp/sslshare/cert.pem.bak and /etc/opt/hp/
sslshare/file.pem.bak respectively.
What To Do
As a workaround, after configuring the host name, run the
/opt/wbem/sbin/gen_wbem_certs utility to create SSL
certificates for HP WBEM Services.
SSL Certificates Generated While
Cold-Installing HP WBEM
Services A.02.07.04 May Not Be
Accepted by WBEM Service
Clients
Known Install and Update Problems 109