HP-UX 11i v3 Installation and Update Guide, February 2007 (Initial Release)

System Requirements for Cold-Installing and Updating
Supported Network Drivers, Mass Storage Drivers, I/O Cards, and Storage Devices
Chapter 2 33
Supported Network Drivers, Mass Storage
Drivers, I/O Cards, and Storage Devices
Before installing HP-UX 11i v3, make sure that the drivers, I/O cards,
and storage devices on your system are supported.
You can run the msv2v3check script to validate whether the drivers,
mass storage I/O cards, and mass storage devices installed on your
system are supported on HP-UX 11i v3. This script will report if any
unsupported drivers, mass storage I/O cards, and mass storage devices
are found on your system.
This script will also check the minimum firmware versions required for
these cards or devices on your system to run properly on HP-UX 11i v3.
You can retrieve the msv2v3check script from the HP software depot at:
http://www.hp.com/go/softwaredepot
For a list of supported and unsupported HP-UX I/O cards and mass
storage devices, refer to the HP-UX Supported I/O Cards Matrix and the
HP-UX Supported Mass Storage Devices Matrix at the HP Technical
Documentation Web site:
http://docs.hp.com
For more details on the msv2v3check script, refer to the white paper
called, HP-UX 11i v2 to 11i v3 Mass Storage Stack Update Guide
available at:
http://docs.hp.com/en/netsys.html#Storage%20Area%20Management
WARNING If third-party (non-HP) storage will be connected to your HP-UX
11i v3 system, HP recommends that you contact your third-party
storage vendor to determine the compatibility of the storage
with HP-UX 11i v3. Check with your third-party storage vendor
for information about any pre-requisites and limitations with
the storage on HP-UX 11i v3.