Interface Card OL* Support Guide

Table 6-3 hotplugd Daemon Log File Messages (continued)
MeaningMessage
hotplugd received an invalid PCI OL* operation on slot slotId. The
oprn value can be one of the following:
• INVALID
• INVALID_INSERTION
• INVALID_REMOVAL
The time value is the time when the Attention Button was pressed.
This error can occur if INSERTION or REMOVAL is received and the slot
is not in the right state. For example, if INSERTION is received and the
slot is not suspended and the driver is attached, then it is an invalid PCI
OL* operation. The PCI OL* operation is also invalid if REMOVAL is
received and the slot is suspended.
This error can also occur if the call to get the slot status information fails.
#oprnNum oprn - slot( slotId
) - time( time ) - Invalid PCI
OL * operation
hotplugd received a PCI OL* operation that it does not understand on
slot slotId. The oprnCode value is the integer representation of the PCI
OL* operation. The time value is the time at which the Attention Button
was pressed.
Contact the HP response center.
#oprnNum - slot( slotId ) - time(
time ) - Invalid PCI OL *
operation (oprnCode)
The Attention Button event was dropped because it was received while
another event was being processed or pending for the same slotId. The
olarIoEvent value is the event that was received. The value can be one
of the following:
• BUS_MODE_MISMATCH
• FREQ_MISMATCH
• INSERTION_POWERED
• INSERTION_UNPOWERED
• NORMAL_REMOVAL
• POWER_FAULT
• SURPRISE_REMOVAL
The time value gives the time at which the event was received.
Wait for the Attention Button processing on a slot to complete before
pressing the Attention Button again.
#oprnNum olarIoEvent - slot( slotId ) -
time( time ) - Dropping AB Event, received,
while processing another event on the slot
The power LED cannot be set to PWR_RAIL mode for the given slotId.
The errMsg value gives the reason for the error.
#oprnNum - slot( slotId ) -
Setting power led to PWR_RAIL mode
failed, errno = errMsg
The power LED cannot be set toPWR_RAIL mode for the given slotId.
The olarErrMsg value gives the reason for the error.
#oprnNum - slot( slotId ) - Setting power
led to PWR_RAIL mode failed, olar_error_no
= olarErrMsg
The hotplugd daemon was invoked with an invalid set of parameters.
Usage : hotplugd <logFileName>
<append|trunc>
The hotplugd daemon cannot fork itself. The errMsg value gives the
reason for the error.
hotplugd : fork() failed,
errno = errMsg
The hotplugd daemon cannot open the given logFile in write mode.
The errMsg value gives the reason for the error.
hotplugd : Could not open log
file : logFile, errno =
errMsg
The hotplugd daemon cannot get the lock on the logFile. The errMsg
value gives the reason for the error.
Another instance of hotplugd may be running.
hotplugd : Could not get lock
on file : logFile, errno =
errMsg
hotplugd Daemon Diagnostics 81