Interface Card OL* Support Guide

2. Prepare to delete:
#/usr/bin/olrad -d slot_ID
Driver instances are removed as part of this action.
3. If present, manually unlock the latch.
4. Physically remove the existing card from the slot.
5. Enter the following command:
#/usr/bin/olrad -D slot_ID
6. To verify that the operation succeeded, enter the following command:
#/usr/bin/olrad -q slot_ID
Configuring an I/O Chassis During Dynamic nPartition Operations
When a Cell, with an I/O chassis connected to it, is activated OnLine as part of the Dynamic
nPartitions operation, the I/O interface(s) present in the corresponding Chassis will not be
configured by default. The Chassis Add option of the olrad command can be used to configure
these interface(s).
The syntax for the Chassis Add command is:
olrad -A -s <cell_hw_path>
Where:
cell_hw_path is the hardware path of the Cell activated online.
De-configuring an I/O Chassis During Dynamic nPartition Operations
When a Cell, with an I/O chassis connected to it, needs to be de-activated OnLine as part of the
Dynamic nPartitions operation, a pre-requisite is that all the I/O interfaces in the corresponding
I/O Chassis must be de-configured. The Chassis Delete option of the olrad command can be
used to de-configure the I/O interfaces.
The syntax for the Chassis Delete command is:
olrad -D -s <cell_hw_path>
Where:
cell_hw_path is the hardware path of a Cell that needs to be deactivated online.
68 The olrad Command