Interface Card OL* Support Guide

Table 2-7 pdweb LED States
DescriptionStateLED
Normal operating mode.NormalSteady OFF
Slot is being identified by request.LocateBLINKing
Operational hardware problem in this slot.AttentionSteady ON
To turn a slot LED to BLINK or OFF, follow these steps:
1. Select a card from the list on the OLRAD Cards tab.
2. Click Turn On/Off Slot LED.
The Turn On/Off LED page is displayed, identifying the selected slot.
Figure 2-29 pdweb Turn On/Off LED
3. Select one of the following buttons:
• Turn LED On to set the LED to the Locate state, Blinking.
• Turn LED Off to set the LED to the Normal state, steady OFF.
• Cancel to leave the slot LED unchanged and return to the OLRAD Cards tab.
A confirmation page appears that confirms the action taken or identifies any errors that have
occurred.
If you turned a slot LED on, the Turn LED Off button is included on this page. You can
remain on this page until you have located the slot, then come back to it to set the slot LED
to Normal.
4. Click Done to return to the OLRAD Cards tab.
Turning the Attention LED to BLINK or OFF 57