vMedia and USB Devices (April 2010)

HP-UX does not currently support the vFlash or vFloppy functionality over iLO/vMedia.

USB-OO version C limitations

The USB-OO driver version C does not support the virtual keyboard, video, and mouse (vKVM) iLO

functionality. To enable this functionality using 11iv2, install version D of the driver and

PHKL_39269. To enable this functionality using 11iv3, install version D of the driver and

PHKL_39820.

HP-UX 11iv3 OE Update for September 2007 Note

When using HP-UX 11iv3 OE Update for September 2007 for HP-UX operating system installation

over iLO/vMedia, the installation may halt after the install kernel has booted and display the

message:

WARNING: Could not find source device in ioscan output. You must select

from the list of devices below to use for the source device:

You will see a list of devices, followed by the message:

Enter the index corresponding to the device to use as the installation

source, 'r' to rescan, or 'q' to reboot:

If a device with the description “USB_SCSI_Stack_Adaptor” is listed, select that index to proceed.

If such a device is not listed, enter “r” in order to perform a rescan. That will print out an updated list

of devices. In that updated list, you should see a device with the description

“USB_SCSI_Stack_Adaptor”. Select that index to proceed with installation.

, 2010

Hewlett

Packard Development Company, L.P. The information

contained herein is subject to change without notice. The only warranties for

HP products and services are set forth in the express warranty statements

accompanying such products and services. Nothing herein should be construed

as constituting an additional warranty. HP shall not be liable for technical or

editorial errors or omissions contained herein.