HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

3. Stop the autoboot by pressing any key.
The boot console menu is displayed. If you need help, enter: HELP.
4. Ensure that Fast Boot is enabled.
a. Select the Configuration Menu: CO
b. If the Fast Boot selection is available, switch Fast Boot ON:
FB ON
The full memory check that is run when Fast Boot is OFF may take several
hours on a large system. (Remember to switch Fast Boot back OFF after
installing HP-UX 11i.)
c. Return to the Main Menu: MA
5. Search for bootable devices, using the choices displayed (for example, enter search
or sea).
NOTE: The search or sea command will only display legacy hardware paths
and will not display agile hardware paths. You will see the agile hardware path
after booting your system. Note that both forms of hardware paths are supported
(legacy and agile) and you can specify either hardware path in the Boot command.
However, only the legacy hardware path can be displayed from the Search
command.
For more information on agile hardware paths, refer to the white paper “The Next
Generation Mass Storage Stack: HP-UX 11i v3” (http://www.docs.hp.com/en/
oshpux11iv3.html#Storage%20Area%20Management).
Output similar to this is displayed:
Main Menu: Enter command or menu > sea all
Searching for potential boot device(s)
This may take several minutes.
To discontinue search, press any key (termination may not be immediate).
IODC
Path# Device Path (dec) Device Type Rev
----- ----------------- ----------- ----
P1 0/0/0/2/1.2 Random access media 4
P2 1/0/0/2/0.6 Random access media 4
P3 1/0/0/2/1.3 Sequential access media 4
48 Cold-installing HP-UX 11i v3 from local media