HP-UX 11i v3 Installation and Update Guide, September 2008 (Update 3 Release)

Figure 6-6 Analysis Dialog
1. If you started a preview session, the preview stops after the analysis. Press Enter
to return to the Software Selection tab.
2. After returning to the Software Selection tab, type l (log) to view the log file, which
presents a view of detailed install information.
3. Review any errors, warnings, or notes. Warnings are simply informational. If there
are any errors, they will need to be resolved before the update can continue.
Step 6: Update
In this step, the system proceeds with the actual update. At the Software Selection tab
type i (install) to start the update process. After the update has started, the system will
typically execute a reboot.
Step 7: Verify Update
After your system has completed its reboot, you will be prompted to change media
when needed. Use the following steps to verify that the update completed successfully:
1. Verify that no errors were encountered before the update began by viewing the
contents of the log file: /var/adm/sw/update-ux.log. You should see output
similar to the following:
Command entered: update-ux -s
depot_server:/var/11iv3/update_depot SWM HPUX11i-OE
NOTE: Output is logged to '/var/adm/sw/update-ux.log'
* Obtaining some information from the source depot.
cp /usr/lbin/swagent /var/adm/sw/tmp/update-ux
compress /var/adm/sw/tmp/update-ux/swagent
uncompress /var/adm/sw/tmp/update-ux/swagent.Z
chmod +x /var/adm/sw/tmp/update-ux/swagent
* Copying an SD agent from the source depot
92 Updating to HP-UX 11i v3