HP-UX 11i v3 Installation and Update Guide, September 2008 (Update 3 Release)

NOTE: CDE is an optional product in HP-UX 11i v3. If you require it, you must
explicitly select the CDE bundle (CDE-xxx). This applies if you need dtterm,
which is located in CDE. For some localization situations, dtterm is required;
therefore CDE must be selected.
6. Use the Software tab to change the software that will be installed on your system,
if desired. If you chose the “No User Interface” option, then you cannot deselect
the default-installed software bundles.
To select or deselect the software bundles:
• Navigate to the Software tab.
• Select any additional software that you want loaded onto your system and
deselect any default-installed software that you do not want loaded on your
system. Browse the list, marking your selections. Use the arrow keys to select
a bundle and the spacebar to change the option.
NOTE: Extra Media Swap May Be Required
During OE media installations, if HPSIM-HP-UX is selected either manually
or through a dependency, you should expect to do an extra media swap:
DVD1, then DVD2, and back to DVD1 (the extra swap), then DVD2.
You should follow the on-screen prompts during media installation. These
prompts will include the extra media swap if you select HPSIM-HP-UX or “all
products” for installation.
• To improve the software selection process, HP-UX 11i v3 offers the following
product categories from which you can select:
Table 5-3 HP-UX 11i v3 Software Product Categories
DescriptionSoftware Category
Compilers and Development ToolsCompilersDevelopment
Core HP-UX FunctionalityCoreOS
Desktop EnvironmentsDesktop
File Systems and Volume MgmtDisksFileSystems
I/O DriversDrivers
High AvailabilityHighAvailability
Internet ServicesInetServices
Internet Software ToolsInternet
Computing Interoperability ToolsInteroperability
Cold-installing HP-UX 11i v3 73