HP-UX 11i v3 Installation and Update Guide, September 2008 (Update 3 Release)

NOTE: Known Problem: When OnLineJFS 5.0 (B3929FB) is selected in the scenario
above, the following selection time warning from update-ux may be seen:
WARNING: The following was found while selecting software:
- There are new revisions of SW available in the source that
would update SW already installed on the system. The newer
revisions are not selected for installation. This could leave
the incompatible old revision of SW on the system. The affected
SW is:
- OnlineJFS.VXFS41-AD-RN,r=B.11.31 replaces
OnlineJFS01.VXFS41-AD-RN,r=4.1.004
What To Do
This warning can be safely ignored. The update will complete successfully despite this
warning. This known problem is also listed in Appendix A (page 107).
Updates to HP-UX 11i v3 with VxVM 4.1
To update HP-UX 11i v2 systems and remain at VxVM 4.1 in HP-UX 11i v3, please
consult this white paper (at http://docs.hp.com) for detailed instructions:
Installation of VxFS and VxVM 4.1 on HP-UX 11i v3 September 2008 Operating Environment
Update Release
To update 11i v3 systems that are already installed with VxVM 4.1 and that you want
to remain at VxVM 4.1 after the update, simply use the default upgrade selections. The
September 2008 OEUR will select only VxFS 4.1 by default, so that the previously
installed version of 11i v3 VxVM 4.1 will remain unchanged (and still usable) on the
system.
130 Installing VxFS and VxVM