HP-UX 11i v3 Installation and Update Guide, March 2010

Table A-1 Messages you can ignore (continued)
Message/actionWhen/where seen
/sbin/rc[14]: /sbin/rc2.d/S700vxatd: not found.
What to do
You can safely ignore this message. Installation is not affected. Veritas
Authentication Service (VRTSat) will start without any problem once the update
is complete.
While updating from a previous
OEUR to the HP-UX 11i v3
September 2008 OEUR and
beyond, the following message
regarding VRTSat may be logged
onto the console:
VxVM sysboot INFO V-5-2-3390 Starting restore
daemon... VxVM vxdmpadm ERROR V-5-1-684 IPC
failure: Configuration daemon is not accessible
VxVM sysboot INFO V-5-2-3811 Starting in boot mode...
What to do
You can safely ignore this message. The update and reboot will be successful,
and there will be no functionality impact.
When updating from HP-UX 11i
v2 to HP-UX 11i v3 September
2008 and beyond, the following
error message is logged to the
console on the final reboot:
cp: cannot access /.secure/etc/*: No such file
or directory
What to do
You can safely ignore this message.
Updating from the HP-UX 11i v2
release to the HP-UX 11i v3
release may cause the following
error to appear in the
swagent.log:
For example:
Jan 21 07:33:02 run1 cmproxyd[1577]: Permission denied
to 127.0.0.1
Jan 21 07:33:41 run1 cmwbemd[1710]: Permission denied
to 127.0.0.1
What to do
These are harmless messages; they do not indicate a problem with the installation.
You can safely ignore these messages or take one of the following actions:
• Install patch PHSS_39614 from the ITRC (http://itrc.hp.com).
• To configure a Serviceguard cluster, or add this system as a node to an existing
cluster, follow directions in the latest edition of Managing Serviceguard manual
(http://www.docs.hp.com/en/ha.html). Make sure you follow the directions
under “Configuring Root Level Access” and “Configuring Name Resolution”
near the beginning of Chapter 5.
After the node is configured into the cluster, the error messages will no longer
appear.
After Serviceguard has been
installed as part of an OE or
separately, the Serviceguard
cmproxyd and cmwbemd
daemons log “Permission denied
to 127.0.0.1” messages to /var/
adm/syslog/syslog.log.
Known install and update problems
Table A-2 (page 79) describes problems currently known to occur while installing and/or updating
to HP-UX 11i v3.
78 Harmless messages and known problems