HP-UX 11i v3 Installation and Update Guide, March 2009 (Update 4 Release)

NOTE: CDE is an optional product in HP-UX 11i v3. If you require it, you must
explicitly select the CDE bundle (CDE-xxx). This applies if you need dtterm,
which is located in CDE. For some localization situations, dtterm is required;
therefore CDE must be selected.
6. Use the Software tab to change the software that will be installed on your system,
if desired. If you chose the “No User Interface” option, then you cannot deselect
the recommended (default-installed) software bundles.
To improve the software selection process, HP-UX 11i v3 offers software product
categories and install types from which you can select. See “HP-UX 11i v3 Operating
Environment Install/Update Structure” (page 133). To select or deselect the software
bundles:
• Navigate to the Software tab.
• If you wish to avoid a manual extra media swap, change the source from
media to a network depot using the Change Depot Location... button in the
lower right hand corner of the Software Tab.
• Select any optional software that you want loaded onto your system and
deselect any recommended (default-installed) software that you do not want.
Browse the list, marking your selections. Use the arrow keys to select a bundle
and the spacebar to change the option.
7. Use the System tab to configure system parameters such as security levels, host
name, IP address, root password, and the time zone. You must set the appropriate
security setting for your system at this time; you can choose to set the other system
parameters now or at the first boot of your system, using set_parms(1M). For more
information about setting appropriate security levels, see “Security Considerations”
(page 37).
To set the appropriate security settings for your system, do the following:
• Navigate to the System tab and select Security Choices.
The four security levels appear. By default, Sec00Tools is selected.
• Select the appropriate security setting for your system.
• Select OK.
8. Use the File System tab to perform a variety of filesystem and disk-configuration
tasks: for example, resizing file systems and adding and removing disks. You can
also re-configure the volume structure and associated file system mount points.
The File System tab will differ in appearance, depending on whether you previously
selected LVM or whole disk on the Basic tab.
Please note that renaming or changing any disk file system structure on which
Ignite-UX installs file system content causes the old file system on that disk to be
Cold-installing HP-UX 11i v3 71