Using HP-UX VLANs (September 2004)

Using lanadmin -V to Administer VLANs

Using the lanadmin -V Command for Administering VLANs

Chapter 5 57

Using lanadmin to Query for VLANs on a System

The following command can be used to query for the list of VPPAs

conﬁgured and their properties.

lanadmin -V scan

A sample output for the successful command is as follows:

VLAN Physical VLAN Pri Pri ToS ToS

NAME

Interface Interface ID Override Override

Name Level Level

lan5000 lan0 5 2 CONF_PRI 25 IP_HEADER

lan5003 lan0 11 5 CONF_PRI 204 CONF_PRI

purple

lan5001 lan1 1 4 IP_HEADER 64 IP_HEADER

newone

lan5002 lan2 3 7 CONF_TOS 200 CONF_PRI

UNNAMED

Note: UNNAMED will be displayed as the VLAN name if there is no

name associated with the VPPA.

Querying for a Single VPPA on a System You can query the Virtual

PPA using the following command:

lanadmin -V info <vppa>

The info command will return the output in the following format when

successful.

Example: lanadmin -V info 5000

VLAN Physical VLAN Pri Pri ToS

ToS NAME

Interface Interface ID Override

Override

Name Level

Level

lan5000 lan0 5 2 CONF_PRI

25 IP_HEADER

Querying for a Base VPPA Value You can determine the minimum

acceptable value for a Virtual PPA using the following command: