Transport Optional Upgrade Release (TOUR) 3.1 Release Notes

Installing TOUR 3.1

Installing TOUR 3.1 on HP-UX 11i v1

This section includes information on TOUR 3.1 software dependencies and installation on

HP-UX 11i v1.

NOTE After TOUR 3.1 is installed on HP-UX 11i v1, the cumulative patch levels are

as follows:

• PHNE_34135 ARPA Transport patch

• PHNE_33729 STREAMS patch

The HP-UX 11i v1 system is also updated with additional defect fixes listed in

“Defect Fixes in This Version” on page 23.

If you install TOUR 3.1 on an HP-UX 11i v1 system with a higher ARPA

Transport or STREAMS patch, some features or defect fixes may be lost. This is

because the modules included in the regular ARPA Transport and STREAMS

patches are replaced by the modules included in TOUR.

Software Dependencies

The following software dependencies are required for TOUR 3.1 on HP-UX 11i v1:

• June 2005 Quality Pack, GOLDQPK11i B.11.11.0506.4 (or later)

• STREAMS patch PHNE_33313 (or later)

NOSYNC Software Dependencies

TOUR 3.1 can be installed without fulfilling the NOSYNC software dependencies. However,

the NOSYNC performance improvement will not be realized unless the following NOSYNC

software dependencies are fulfilled:

• DLPI patch PHNE_33704 (or later)

• HP-UX IPFilter A.03.05.12 (if IPFilter is used)

You can download the required patches from the HP IT Resource Center Web site at

http://www2.itrc.hp.com/service/patch/mainPage.do.

Run the swinstall command

HP-UX IPv6 and HP-UX Mobile IPv6 A.01.00 are optional. IF you do not want to install these

products, deselect them in an interactive swinstall session. Else, install the bundle as

follows: