Transport Optional Upgrade Release (TOUR) 2.0 Release Notes HP-UX 11i v2 Manufacturing Part Number: 5990-8499 April 2004 United States © Copyright 2004 © Hewlett-Packard Development Company L.P. All rights reserved.
Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes The information in this document applies to Transport Optional Upgrade Release (TOUR 2.0) for HP-UX 11i v2.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Announcement Announcement Transport functionality is typically delivered as part of the HP-UX operating system. Transport Optional Upgrade Release (TOUR) is an additional, fully supported, web release that delivers transport functionality and other networking features independently of major HP-UX releases. Later versions of TOUR completely supersede previous TOUR versions.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version What Is in This Version TOUR 2.0 includes the following components: • HP-UX Transport Enhancements (IPv4 and IPv6) • HP-UX Point-to-Point Protocol (PPP) enhancements (PPPoE and PPPv6) • HP-UX Mobile IPv6 A.01.00 Except for some transport enhancements (described below) the components and features in TOUR 2.0 are supported on both HP-UX 11i v1 and HP-UX 11i v2. This document focuses on what is new in TOUR 2.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version • netstat Enhanced to Support the Display of 64-bit MIB Counters: netstat in TOUR 2.0 has been enhanced to support the display of 64-bit MIB (Management Information Base) counters. Thus, some of the netstat fields have the potential to display widened output. This can cause a wraparound effect on 80-character displays.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version IMPORTANT As a result of supporting RFC 2893, tunnel configuration on HP-UX IPv6 bundled as part of TOUR 2.0, requires specific changes from tunnel configurations on previous HP-UX IPv6 releases. If you have previously set up any tunneling on your HP-UX 11i v2 IPv6 system(s) you will need to make changes to your TOUR 2.0 system for tunneling to work.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version IP6-in-IP tunnel configuration allows transmission of IPv6 packets encapsulated in an IPv4 header. IP6-in-IP represents the tunneling scenario where isolated IPv6 domains are communicating across IPv4 networks. IP6-in-IP tunneling is not new in TOUR 2.0, it is supported in base (default) HP-UX 11i v2.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version HP-UX Mobile IPv6 A.01.00 IPv6 addresses are topologically correct, meaning IPv6 nodes attached to the same physical network or LAN segment must have the same IPv6 network address prefix.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version Home Agent Home Agents are nodes or routers that provide mobility services to Mobile Nodes from their home network. During Mobile IPv6 basic operation, when a Mobile Node is attached to a foreign network— any network other than its home network—it gets a temporary Care-of Address identifying its current location.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version Dynamic Home Agent Address Discovery With Dynamic Home Agent Address Discovery, a Mobile Node only needs a home network prefix configured and it can dynamically find the address of a Home Agent on its home network when it needs to register its Care-of Address. Prefix Discovery Prefix Discovery allows a Mobile Node to get network prefix information about its Home Network and to configure its Home Address if needed.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes What Is in This Version HP-UX Mobile IPv6 also includes a command line tool, mip6config, to quickly create, edit, and verify mip6mod Mobile IPv6 configuration files. The mip6config tool verifies mip6mod configuration parameters you configure and displays error messages after detecting invalid syntax or values.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes System Requirements System Requirements This section lists the resources needed and the software requirements for installing and running TOUR 2.0 on HP-UX 11i v2. Supported Operating Systems TOUR 2.0 is supported on the following 32- or 64-bit systems: • HP-UX 11i Version 1.0 (B.11.11) PA-RISC servers • HP-UX 11i Version 2.0 (B.11.23) Intel Itanium servers Minimum System Resources for HP-UX 11i v2 HP-UX 11i v2 TOUR 2.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Installing TOUR 2.0 Installing TOUR 2.0 This section includes information on obtaining and installing TOUR 2.0. It includes information needed before and after the TOUR 2.0 installation. NOTE TOUR 2.0 is not compatible with some versions of IPSec. Before installing TOUR 2.0, refer to the section titled “TOUR 2.0 and IPSec” on page 17. Installation Instructions To install TOUR 2.0, complete the following steps: Step 1.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Installing TOUR 2.0 Notice that the target selection specified in the swinstall example is “TOUR”, not “TOUR2”,since the TOUR 2.0 product bundle name is “TOUR”. The product bundle version reflects the version change from 1.0 to 2.0. The Mobile IPv6 product is optional. If you do not want to install Mobile IPv6, use interactive swinstall and deselect the Mobile IPv6 product.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Installing TOUR 2.0 If you need to remove TOUR 2.0, be aware of the following: • The save area under /usr/contrib/TOUR/save_area must be intact (after installing TOUR 2.0, files in this directory must not be removed). • Removing TOUR 2.0 restores the base (default) HP-UX 11i v2 transport software. To remove (un-install) TOUR 2.0, do the following: Step 1. Use the swremove command and specify the TOUR product.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Installing TOUR 2.0 TOUR 2.0 and IPSec TOUR 2.0 is only compatible with, and is a software requirement for, (when available) IPSec (J4256AA) version A.02.00 or greater. It is not compatible with earlier versions of IPSec. If you try to install TOUR 2.0 on a system that has an earlier version of IPSec (J4256AA) you will see the following error message: ERROR: An older IPSec product (J2456AA) is already installed.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Related Documentation Related Documentation The following documents, available on http://www.docs.hp.com, provide additional information on TOUR 2.0 and its components: • HP-UX IPv6 Transport Administrator’s Guide for TOUR 2.0 • HP-UX IPv6 Porting Guide • HP-UX IPv6 Transition Mechanisms (White Paper) • HP-UX PPPoE/v6 Administrator’s Guide for TOUR 2.0 • HP-UX PPP Enhancements - PPPoE and PPPv6 (White Paper) • HP-UX Mobile IPv6 A.01.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Limitations Limitations This section includes information on the limitations that exist for HP-UX 11i v2 TOUR 2.0 components. IPv6 Transport Limitations The limitations of IPv6 included in HP-UX 11i v2 TOUR 2.
Transport Optional Upgrade Release (TOUR) 2.0 Release Notes Patches and Fixes in This Version Patches and Fixes in This Version This section contains information on fixes available in TOUR 2.0 for TOUR 2.0 components. HP-UX Transport Fixes No fixes for HP-UX transport (IPv4 and IPv6) are needed or included as part of TOUR 2.0 for HP-UX 11i v2. HP-UX PPPoE/v6 Fixes No fixes for HP-UX PPPoE/v6 are needed or included as part of TOUR 2.0 for HP-UX 11i v2. HP-UX Mobile IPv6 A.01.
