ONC With Publickey LDAP Support Software Pack Release Notes

ONC with Publickey LDAP Support Software Pack
Installing the ONC EP/NCF Software Pack
Chapter 110
Verifying the Installation
Use the following commands to verify the ENHKEY software bundle installation:
• To verify that there were no errors during the ENHKEY bundle installation, run the
following command:
swverify ENHKEY
If the ENHKEY bundle is successfully installed, the returned status is 0:
0
• To verify that the ENHKEY software bundle is successfully installed, run the following
command:
swlist -l product ENHKEY
If the ENHKEY software bundle is successfully installed, the contents of the bundle are
displayed as follows:
ENHKEY.EnhancedKey
ENHKEY.PHKL_34094
ENHKEY.PHKL_31500
ENHKEY.PHNE_35119
ENHKEY.PHNE_35120
• To verify that the NCF products, EnhancedKey, are installed on the system, execute the
following command on an HP-UX 11i v2 PA system:
what /usr/sbin/newkey_ldap /usr/bin/chkey_ldap /usr/lib/enhlibnsl.1 \
/usr/lib/pa20_64/enhlibnsl.1
If the NCF products are successfully installed, the output is shown as follows:
/usr/sbin/newkey_ldap:
Enhanced Key Components Version B.11.23.01
/usr/bin/chkey_ldap:
Enhanced Key Components Versions B.11.23.01
/usr/lib/enhlibnsl.1:
ENhanced Key Components Version B.11.23.01
/usr/lib/pa20_64/enhlibnsl.1:
Enhanced Key Components Version B.11.23.01
• To verify that the NCF products, EnhancedKey, are installed on the system, execute the
following command on an HP-UX 11i v2 IA system: