HP Fibre Channel Mass Storage Adapters Support Guide, February 2007

Chapter 3
Troubleshooting and Maintenance
fcmsutil
38
/dev/fcd1
If the device file does not display in the ioscan output, run /sbin/rc2.d/S900hpfcms start to recreate the
device file.
To use the basic fcmsutil command, enter the following command:
/opt/fcms/bin/fcmsutil /dev/
<device_filename>
If you use fcmsutil with dual port universal adapter A6826A, enter the following command:
fcmsutil /dev/fcd
x
where:
x is the number assigned to the adapter port being accessed.
The output is similar to the following example:
Vendor ID is = 0x001077
Device ID is = 0x002312
PCI Sub-system Vendor ID is = 0x00103c
PCI Sub-system ID is = 0x0012ba
PCI Mode = PCI-X 66 MHZ
ISP Code version = 3.2.26
ISP Chip Version = 3
Topology = PTTOPT_FABRIC
Link Speed = 1Gb
Local N_Port_id is = 0x211413
Previous N-Port_id is = None
N_Port Node World Wide Name = 0x50060b00001d21fd
N_Port Port World Wide Name = 0x50060b00001d21fc
Switch Port World Wide Name = 0x2014080088404800
Switch Node World Wide Name = 0x1000080088404800
Driver state = ONLINE
Hardware Path is = 0/4/1/0
Maximum Frame Size = 2048
Driver-Firmware Dump Available = NO
Driver-Firmware Dump Timestamp = N/A
Driver Version = @(#) libfcd.a HP Fibre
Channel ISP 23xx Driver B.11.11.02
/ux/kern/kisu/FCD/src/common/wsio/fcd_init.c:Feb 19 2004,17:46:19
**********************************************************
Check to see that the driver state is ONLINE.
You cannot use all fcmsutil options with all the adapters. In the manpage for fcmsutil, (QL) follows the
options that can be used with the FibreChannel port of the A6826A, A9782A, A9784A, AB378A, AB379A, and
AB465A adapters. Options without the (QL) indicator can be used with all adapters.
You can the echo, test, reset, and get options with fcmsutil. Use other fcmsutil options only at the
request of your HP support representative.
Reading VPD Information
You can use fcmsutil with Fibre Channel Host Bus Adapters to read Vital Product Data (VPD) information
on the adapter, which can be useful in troubleshooting problems remotely. The command for retrieving VPD
information is as follows: