HP Fibre Channel Mass Storage Adapters Support Guide, February 2007

Chapter 1

Adapter Overview

AB465A Fibre Channel-Ethernet Combination Card

The HP Fibre Channel component of the HP AB465A Fibre Channel-Ethernet combination card uses the

same driver (FibrChanl-01) as the HP A6826A Fibre Channel adapter. It operates in PCI 66 MHz and PCI-X

66 MHz / 133 MHz bus speeds with a 32-bit or 64-bit bus width. It operates in 3.3V slots only.

For AB465A installation information see the AB465A PCI-X 2-Port 2 Gigabit Fibre Channel and 2-Port

Gigabit Ethernet Combination Card Installation Guide at:

http://docs.hp.com/en/netcom.html#Fibre%20Channel

For Fibre Channel Troubleshooting and Maintenance information, see Chapter 3, “Troubleshooting and

Maintenance,” on page 33.

Figure 1-9 AB465A Fibre Channel-Ethernet Combination Card

For supported configurations and firmware requirements specific to the A9784A combination card, see the HP

AB465A Combination Fibre Channel / Gigabit Ethernet Adapter Support Matrix at:

http://docs.hp.com/en/netcom.html#Fibre%20Channel

PCI-X

133 MHz