Interface Card OL* Support Guide

ManualsBrandsHP ManualsSoftwareHP-UX 11i v2 Foundation OE LTU

Chapter 4

olrad - Command Line Interface

Options, Scripts, & Logging

Options

Details for some options are discussed below. See the olrad (1M) manpage for a complete listing of options,

usage, syntax, and details of their use.

-a

slot_id

Prepare to add a card to system at the speciﬁed slot. Critical resource

analysis is run to ensure that the current card addition onto the system

will not cause disruption in the functioning of the system. The driver

scripts (pref_replace and prep_replace) for affected slots (if any) are

run and the drivers associated with the affected slots are suspended. The

slot power is turned OFF, and the attention LED at the corresponding slot

is set to BLINK mode.

-A

slot_id

Post add phase. The slot power is turned ON, the drivers associated with

all affected slots are resumed. ioscan is run and if the card is claimed, the

driver scripts, post_add for the current slot and post_replace for

affected slots (if any), are run and the attention LED at the corresponding

slot is turned OFF.

-r

slot_id

Prepare to replace a card on the system at the speciﬁed slot. Critical

resource analysis is run to ensure that the current card replacement on

the system will not cause disruption in the functioning of the system. The

driver scripts (pref_replace and prep_replace) for the affected slots (if

any) and the current slot are run. The drivers associated with the current

slot and affected slots are suspended. The target slot is powered off and

the attention LED is set to BLINK at the corresponding slot.

-R

slot_id

Post Replace phase. The target slot power is turned ON. The suspended

drivers are resumed and the driver scripts (post_replace) for the current

slot and the affected slots (if any) are run. The attention LED at the

corresponding slot is set to OFF.

-q Displays the status of all OL* capable slots in the system. Slots with the

same bus number are treated as shared slots.

-I

flag slot_id

Controls the state of the Attention LED. The valid values for this ﬂag

option are: ATTN and OFF. Based on the ﬂag value, the Attention LED at

the corresponding slot is set to the appropriate state. ATTN turns the

LED to BLINK. The ﬂags are not case-sensitive.

-C

slot_id

Runs critical resource analysis routine on the speciﬁed slot_id and display

the results. It checks for critical resources on all affected hardware paths

associated with the speciﬁed slot. It analyzes ﬁle systems, volumes,

processes, networking, swap, and dump; and generates a report of affected

resources.

Scripts

When performing an OL* operation on a slot, olrad runs pref_replace and prep_replace scripts in the

pre-OL* phase and post_add and post_replace driver scripts in post-OL* phase.