Interface Card OL* Support Guide

Chapter 4
olrad - Command Line Interface
Using olrad
79
Step 2. Prepare to replace:
/usr/bin/olrad -r slot_ID
A CRA is performed as part of this action.
Step 3. Manually unlock the latch (if present).
1
Replace the existing card in the slot with another card.
Press latch to the locked position (if present).
1
The new card must use the same drivers as the replaced card.
Step 4. Post Replace:
/usr/bin/olrad -R slot_ID
Step 5. Verify the success of the operation, slot power should be ON, driver is OLAR capable, and so on.
/usr/bin/olrad -q slot_ID
Turning the Attention LED to BLINK or OFF
To turn the Attention LED to BLINK
/usr/bin/olrad -I ATTN slot_ID
To turn the Attention LED to OFF
/usr/bin/olrad -I OFF slot_ID