Interface Card OL* Support Guide

Chapter 3

Attention Button - Direct Slot Control

Using the Attention Button

It is advised to determine the condition of all slots run the following command prior to using the Attention

Button. This can be accomplished using the olrad command or through the pdweb tool. For additional details

of the olrad command, see Chapter 4, “olrad - Command Line Interface,” on page 75, to view slot information

using the pdweb tool, “Viewing Slot Information” on page 43.

Example 3-1 Example of the olrad -q command output

# olrad -q

Driver(s)

Capable

Slot Path Bus Max Spd Pwr Occu Susp OLAR OLD Max Mode

Num Spd Mode

0-0-3-1 4/0/1/0 21 66 N/A On Yes No Yes N/A PCI N/A

0-0-3-2 4/0/2/0 42 66 N/A On Yes No Yes N/A PCI N/A

0-0-3-3 4/0/3/0 63 66 N/A On Yes No Yes N/A PCI N/A

0-0-3-4 4/0/4/0 84 66 N/A On Yes No Yes N/A PCI N/A

0-0-3-5 4/0/6/0 105 66 N/A On Yes No Yes N/A PCI N/A

0-0-3-6 4/0/14/0 234 66 N/A On Yes No Yes N/A PCI N/A

Refer to the olrad (1M) manual page and Chapter 4, “olrad - Command Line Interface,” on page 75, for

information on this command.

In the example above, slots 1 & 2 are occupied and the slot power is ON, while the remaining slots are not

occupied and the power is OFF to the slot.

In the output, slots with the same bus number are treated as shared slots.