Interface Card OL* Support Guide

Chapter 2

pdweb - Peripheral Device Tool Web Interface

Replacing a Card Online

Step 2. Click the button appropriate to your course of action.

— If you chose [Power Off] or [Force Power Off], you are advanced to Step 2 of the Replace Card

process and these events are initiated:

— the amber attention LED is set to ﬂashing

— the target slot is powered off if necessary

— the target slot green power LED is set to steady OFF

— If any other button is chosen, control returns to the OLRAD Cards tab and

the state of the target slot is unchanged.

CAUTION Do not push the Attention Button on the slot, if it exists, as this causes the slot to be

powered on and an attempt to bring the card online prematurely is executed by the

system.

IMPORTANT Only replace a card in a slot when the Power LED is OFF.

At the system, locate the target slot then conﬁrm that the green power LED is off and that the

amber attention LED is ﬂashing before proceeding. If this is not the case, refer to “Messages from

pdweb Actions” on page 90.

System Critical

Warning

[Done] Terminate the card replacement as

it would be detrimental to the

system.

Error [Done] Terminate the card replacement as

a problem exists that should be

investigated using the information

provided in the CRA.

Table 2-5 pdweb Replace a Card CRA Results (Continued)

CRA Result

Available

Actions

Suggested Course of Action