HP WDB GUI Reference Manual (August 2006)

Installing WDB GUI
Installation Overview
Chapter 216
Installation Overview
The following sections describe the requirement for installing WDB GUI:
Supported Configurations
WDB GUI 5.3 is supported on HP-UX 11.x systems.
Disk Space Requirements
Installation Instructions
WDB GUI requires HP WDB. If you do not have HP WDB 5.2 installed on your system, it will
be loaded automatically when you install WDB GUI.
Use the SD-UX swinstall command to install your software. It invokes a user interface that
leads you through the installation. It also gives you information about disk space
requirements, version numbers, product descriptions, and dependencies.
NOTE When you install the WDB GUI with swinstall, select both the WDB GUI and
WDB products. If you select only the WDB GUI product, the WDB
documentation does not load automatically.
For more information about swinstall, refer to the sd(5) man page, the swinstall(1m) man
page, or the online help in swinstall .
Filesets
The WDB-GUI product contains the following subproducts:
Table 2-1 Disk Space Requirements for Installing WDB GUI
Configuration On 11.0 (PA) On 11.23 (IA)
WDB-GUI only
(WDB already installed)
8 MB 8 MB
WDB and WDB-GUI 16 MB 16 MB