HP-UX Memory File System (MemFS) 2.0

Chapter 2 15
2 Installing, Configuring, Tuning, and
Removing HP-UX Memory File System
This chapter describes how to install, configure, tune and remove HP-UX Memory File
System (MemFS).
The following topics are discussed:
• Installing HP-UX Memory File System
• Configuring Memory File System
• Tuning Memory File System
• Removing Memory File System
Installing HP-UX Memory File System
You can install HP-UX Memory File System (MemFS) either non-interactively or
interactively.
Installing HP-UX MemFS in the Non-Interactive Mode
To install MemFS in non-interactive mode, enter the following command:
# swinstall -x reinstall=false -x autoreboot=true -s <depot-path> MemFS
Installing MemFS in the Interactive Mode
To install MemFS in interactive mode, enter the following command:
# swinstall -x reinstall=false -x autoreboot=true -s <depot-path>
NOTE If VxFS 4.1 is installed on the system, the new EnableVxFS bundle (which
delivers /sbin/mount_enh) command must be installed on the same system
where MemFS v2 is installed. If VxFS 4.1 has been installed previously and the
new EnableVxFS bundle, that supports MemFS v2, has not been installed,
MemFS mounts fail.