HP-UX 11i Version 2 June 2007 Release Notes

Hardware-Specific Information
Networking and Mass Storage Drivers
Chapter 4
94
and Upgrade Guide, available at http://www.hp.com/learn/isee. Please note that HP
Instant Support Enterprise Edition is only supported on servers, not HP-UX
workstations.
Enabling ISEE
ISEE is installed in a disabled state. To enable the client complete the following steps:
1. In the file /etc/rc.config.d/hpservices.conf change the value of START_TUNER
from 0 to 1.
2. In the file /etc/rc.config.d/rstemsListener change the value of RST_LISTENER
from 0 to 1.
3. Execute /sbin/init.d/hpservices start.
4. Execute /sbin/init.d/rstemsListener start.
Configuring ISEE
The ISEE configuration process is documented in the section titled “Configuring ISEE
after an Individual Installation” in the HP Instant Support Enterprise Edition Client
Installation and Upgrade Guide. Additional information about ISEE and HP-UX servers
can be found in Appendix A.
Performance
There are no known performance issues.
Documentation
Information about ISEE, including the HP Instant Support Enterprise Edition Client
Installation and Upgrade Guide, is available at http://www.hp.com/learn/isee.
For a complete list of ISEE-supported operating systems and hardware devices, please
view the ISEE supported products Web page at
http://www.hp.com/hps/hardware/hw_products.html
Obsolescence
Not applicable.
Networking and Mass Storage Drivers
HP-UX 11i v2 includes drivers for networking and mass storage adapter cards. The
drivers are described in the following sections:
Always-Installed Networking Drivers (see page 95)
Selectable Networking Drivers (see page 96)
Always-Installed Mass Storage Drivers (see page 97)