HP-UX 11i Version 2 June 2007 Release Notes

Hardware-Specific Information
Supported Systems
Chapter 4
104
Impact
FibrChanl-02 provides support for new PCIe fibre channel adapter cards.
Compatibility
There are no known compatibility issues.
Performance
There are no known performance issues.
Documentation
For further information, see the following documents, available at
http://docs.hp.com/en/netcom.html#Fibre%20Channel (from http://docs.hp.com,
navigate to I/O Cards and Networking Software, then to Fibre Channel):
• Fibre Channel Mass Storage Adapter Installation Guide — for AD299A
• FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v2 Release
Notes
• Fibre Channel Mass Storage Adapter Support Guide — for AD299A
For information about supported cards, see the support matrixes listed in their own
subsection at http://docs.hp.com/en/netcom.html#Fibre%20Channel.
Obsolescence
Not applicable.
Supported Systems
HP-UX 11i v2 supports only the 64-bit version of the HP-UX kernel. This release of
HP-UX 11i v2 release fully supports the following HP 9000 servers and HP Integrity
servers, as well as the new PA-8900 processor.
NOTE HP-UX 11i v2 is not supported on PA-RISC Workstations. HP recommends that
PA-RISC Workstation customers use HP-UX 11i v1.
The HP-UX 11i v2 May 2005 release was the last release supported on the
Itanium-based zx2000 and zx6000 workstations. These workstations have been
discontinued as of September 2004.
Additional information regarding HP servers and workstations can be found at the
following Web sites:
• HP Servers and Enterprise Systems
http://hp.com/go/servers
•HP Workstations