HP-UX 11i Version 2 June 2006 Release Notes
Table Of Contents
- HP-UX 11i Version 2 June 2006 Release Notes
- Legal Notices
- Publication History
- Typographic Conventions
- 1 Overview of the Release Notes
- 2 Introduction to HP-UX 11i Version 2
- 3 What is New at a Glance
- What is in This Chapter?
- What is New in the June 2006 Release?
- What is New in the March 2006 Release?
- What is New in the December 2005 Release?
- What is New in the May 2005 Release?
- What is New in the September 2004 Release?
- What is New in the March 2004 Release?
- What is New in the Initial (October 2003) HP-UX 11i v2 Release?
- 4 Hardware-Specific Information
- What is in This Chapter?
- Hardware Enablement Patch Bundle for HP-UX 11i v2
- HP Instant Support Enterprise Edition
- Networking and Mass Storage Drivers
- Always-Installed Networking Drivers
- Selectable Networking Drivers
- Always-Installed Mass Storage Drivers
- Supported Systems
- Finding Firmware Information
- Utility Pricing Solutions
- 5 General System Administration
- What is in This Chapter?
- Feature Enablement Patch Bundle (FEATURE11i)
- HP Integrity Virtual Machines Provider
- HP Integrity VM Support Library
- HP Partitioning
- HP Serviceguard WBEM Providers
- HP System Management Homepage
- HP WBEM Services for HP-UX
- HP-UX Kernel Configuration
- Ignite-UX
- Online Diagnostics
- Quality Pack Patch Bundle
- Software Distributor
- Update-UX
- Utilization Provider
- 6 Disk and File Management
- 7 Internet and Networking
- 8 Security
- 9 Commands and System Calls
- 10 Libraries and Programming
- 11 Internationalization
- 12 Other Functionality
General System Administration
Ignite-UX
Chapter 5
118
http://www.docs.hp.com/en/IUX/infolib.html
Impact
There are no impacts other than those described previously.
Compatibility
• All SAS devices are not supported by Ignite-UX.
• All SAS disk devices are not supported by Ignite-UX.
• Older versions of Ignite-UX do not contain support for SAS devices so these devices
cannot be detected during installation. It is not possible to use SAS devices for
installation or recovery unless Ignite-UX version C.6.8.x is used.
• If you are using SAS devices, you must use Ignite-UX version C.6.8.x and the HP-UX
11i v2 June 2006 release to avoid a system hang during installations. A system hang
occurs when the system reboots after installation because the SAS device layout is
unknown. This is a result of a kernel being installed from an older version of
Ignite-UX that did not contain SAS support.
• Ignite-UX does not support configurations that include both VxVM 3.5 and VxVM
4.1 in the same image. Please make sure that your installation and recovery images
contain only one version of the VxVM product.
Performance
There are no known performance issues.
Documentation
The Ignite-UX product Web site, containing information and documentation, has been
updated for this release and is found at
http://www.docs.hp.com/en/IUX/
The Ignite-UX Administration Guide, PN B2355-90970, Edition 23, has been updated to
reflect all the changes to the product for this release and is found at
http://www.docs.hp.com/en/IUX/infolib.html
The Ignite-UX Reference Guide, PN 5187-4555, Edition 8, has been updated to reflect all
the changes to the manpages for this release and is found at
http://www.docs.hp.com/en/IUX/infolib.html
The Ignite-UX Release Notes have been updated for this release. These release notes are
now available in Japanese. These documents are found at
http://www.docs.hp.com/en/IUX/infolib.html
Obsolescence
Not applicable.