HP-UX 11i Version 2 Installation and Update Guide, September 2004
Table Of Contents
- 1 Welcome to HP-UX 11i Version 2
- 2 System Requirements for Cold-Installing and Updating
- 3 Choosing an Installation Method
- Supported Cold-Install Paths to HP-UX 11i v2
- Supported Update Paths to HP-UX 11i v2
- Deciding Which Method to Use
- Time to Complete a Cold Install or Update
- When to Cold-Install
- When to Update
- Additional Cold-Install Considerations
- Additional Update Considerations
- Requirement for Updating from HP-UX 11i v1.6 (B.11.22)
- Requirement for Updating from Earlier Releases of HP-UX 11i v2 (B.11.23)
- HP Service Partition Is Not Created During Update (Itanium-based Systems Only)
- Update-UX Contains a Default-Installed Selection File
- Update-UX Creates Two Backup Configurations
- Security Considerations
- Standard HP-UX Bundle Considerations
- Online Diagnostics
- Offline Diagnostics
- The Next Step
- 4 Preparing to Install or Update to HP-UX 11i v2
- 5 Cold-Installing HP-UX 11i v2
- 6 Updating to HP-UX 11i v2
- 7 Installing HP Applications and Patches
- 8 Verifying System Install or Update
- A Data Collection Tables
- B Known Problems and Troubleshooting
- C Controlling Memory Utilization of VxFS 3.5 on HP-UX
- D Software Distribution Media
- HP-UX 11i v2 Core Software Bundles
- HP-UX 11i v2 Always-Installed Patch Bundles
- HP-UX 11i v2 Always-Installed Software Bundles
- HP-UX 11i v2 Always-Installed Network and Mass Storage Drivers
- HP-UX 11i v2 Default-Installed Software Bundles
- HP-UX 11i v2 Selectable Software Bundles
- HP-UX 11i v2 Selectable Network Drivers
Choosing an Installation Method
Security Considerations
Chapter 366
Table 3-7 Additional Sec30DMZ Install-time Security Settings
1
Category Actions
IPFilter
Configuration
2
Includes all IPFilter settings in Table 2-4 and:
Block incoming HIDS agent connections
3,4
Block incoming WBEM connections
5
Block incoming web admin connections
Block incoming web admin autostart connections
Block all traffic except HP-UX Secure Shell
1. Applies all security configuration settings in Table 3-5 and Table 3-6
2. IPFilter rules are applied via a custom rules file located at
/etc/opt/sec_mgmt/bastille/ipf.customrules
3. Settings applied only if software is installed
4. HP-UX Host IDS is a selectable software bundle and only available for commercial
servers
5. WBEM is required for several HP management applications including
Servicecontrol Manager and ParMgr