HP-UX 11i Version 2 Installation and Update Guide, September 2004
Table Of Contents
- 1 Welcome to HP-UX 11i Version 2
- 2 System Requirements for Cold-Installing and Updating
- 3 Choosing an Installation Method
- Supported Cold-Install Paths to HP-UX 11i v2
- Supported Update Paths to HP-UX 11i v2
- Deciding Which Method to Use
- Time to Complete a Cold Install or Update
- When to Cold-Install
- When to Update
- Additional Cold-Install Considerations
- Additional Update Considerations
- Requirement for Updating from HP-UX 11i v1.6 (B.11.22)
- Requirement for Updating from Earlier Releases of HP-UX 11i v2 (B.11.23)
- HP Service Partition Is Not Created During Update (Itanium-based Systems Only)
- Update-UX Contains a Default-Installed Selection File
- Update-UX Creates Two Backup Configurations
- Security Considerations
- Standard HP-UX Bundle Considerations
- Online Diagnostics
- Offline Diagnostics
- The Next Step
- 4 Preparing to Install or Update to HP-UX 11i v2
- 5 Cold-Installing HP-UX 11i v2
- 6 Updating to HP-UX 11i v2
- 7 Installing HP Applications and Patches
- 8 Verifying System Install or Update
- A Data Collection Tables
- B Known Problems and Troubleshooting
- C Controlling Memory Utilization of VxFS 3.5 on HP-UX
- D Software Distribution Media
- HP-UX 11i v2 Core Software Bundles
- HP-UX 11i v2 Always-Installed Patch Bundles
- HP-UX 11i v2 Always-Installed Software Bundles
- HP-UX 11i v2 Always-Installed Network and Mass Storage Drivers
- HP-UX 11i v2 Default-Installed Software Bundles
- HP-UX 11i v2 Selectable Software Bundles
- HP-UX 11i v2 Selectable Network Drivers
System Requirements for Cold-Installing and Updating
Unsupported Servers and Workstations
Chapter 2 39
Unsupported Servers and Workstations
This release of HP-UX 11i v2 does not support the following HP Integrity
Servers, HP 9000 Servers, and HP 9000 Workstations:
Itanium-1 based Systems
• HP Integrity rx4610 server
• HP Integrity rx9610 server
• HP Integrity i2000 workstation
PA-RISC Servers
• All 32-bit servers (including 32-bit A-Class servers A180 and A180C)
• All D-Class servers
• All R-Class servers
• All E-Class servers
• All K-Class servers
• All T-Class servers
• All V-Class servers
PA-RISC Workstations
This HP-UX 11i v2 release is not supported on PA-RISC Workstations.
HP recommends customers use an HP-UX 11i v1 release.
• B132L, B132L+, B160L, B180L
• B1000, B2000, B2600
• C100, C110, C160L, C160, C180, C200, C240, C360
• C3000, C3600, C3650, C3700, C3750, C8000
• J200, J210, J210XC, J280, J282, J2240
• J5000, J5600, J7000, J6000, J6700, J6750
• 705, 710, 712, 715/33, 715/50, 715/75, 715/64, 715/80, 715/100,
715/100XC, 720, 730, 735, 750, 755, 725/50, 725/75, 725/100