HP-UX 11i Version 2 Installation and Update Guide, September 2004
Table Of Contents
- 1 Welcome to HP-UX 11i Version 2
- 2 System Requirements for Cold-Installing and Updating
- 3 Choosing an Installation Method
- Supported Cold-Install Paths to HP-UX 11i v2
- Supported Update Paths to HP-UX 11i v2
- Deciding Which Method to Use
- Time to Complete a Cold Install or Update
- When to Cold-Install
- When to Update
- Additional Cold-Install Considerations
- Additional Update Considerations
- Requirement for Updating from HP-UX 11i v1.6 (B.11.22)
- Requirement for Updating from Earlier Releases of HP-UX 11i v2 (B.11.23)
- HP Service Partition Is Not Created During Update (Itanium-based Systems Only)
- Update-UX Contains a Default-Installed Selection File
- Update-UX Creates Two Backup Configurations
- Security Considerations
- Standard HP-UX Bundle Considerations
- Online Diagnostics
- Offline Diagnostics
- The Next Step
- 4 Preparing to Install or Update to HP-UX 11i v2
- 5 Cold-Installing HP-UX 11i v2
- 6 Updating to HP-UX 11i v2
- 7 Installing HP Applications and Patches
- 8 Verifying System Install or Update
- A Data Collection Tables
- B Known Problems and Troubleshooting
- C Controlling Memory Utilization of VxFS 3.5 on HP-UX
- D Software Distribution Media
- HP-UX 11i v2 Core Software Bundles
- HP-UX 11i v2 Always-Installed Patch Bundles
- HP-UX 11i v2 Always-Installed Software Bundles
- HP-UX 11i v2 Always-Installed Network and Mass Storage Drivers
- HP-UX 11i v2 Default-Installed Software Bundles
- HP-UX 11i v2 Selectable Software Bundles
- HP-UX 11i v2 Selectable Network Drivers

Known Problems and Troubleshooting
Known Install and Update Problems
Appendix B 161
update() Hang Panic
on Large Memory
Systems
During a reboot -r process, large memory systems may
hang due to the failure of the update() function called during
the reboot. This failure is caused by a timer value
(UpdateHangTimeout) expiring before update() is finished.
This issue is known to be a problem for rx8620 32-way servers
with 128 GB of memory.
To mitigate this problem, increase the UpdateHangTimeout
timer value to 20 minutes using adb (user input in bold):
adb -w /stand/vmunix /dev/kmem
abd> UpdateHangTimeout /W 0x1d4c0
UpdateHangTimeout: 0x120000 =0x1d4c0
abd> UpdateHangTimeout/D
UpdateHangTimeout:
UpdateHangTimeout: 120000
NOTE: The system may still appear to be hung during reboot
for at least 20 minutes if the load is high.
Table B-1 Known Install and Update Problems (Continued)
Problem Description/Action