HP-UX 11i Version 2 Installation and Update Guide, September 2004
Table Of Contents
- 1 Welcome to HP-UX 11i Version 2
- 2 System Requirements for Cold-Installing and Updating
- 3 Choosing an Installation Method
- Supported Cold-Install Paths to HP-UX 11i v2
- Supported Update Paths to HP-UX 11i v2
- Deciding Which Method to Use
- Time to Complete a Cold Install or Update
- When to Cold-Install
- When to Update
- Additional Cold-Install Considerations
- Additional Update Considerations
- Requirement for Updating from HP-UX 11i v1.6 (B.11.22)
- Requirement for Updating from Earlier Releases of HP-UX 11i v2 (B.11.23)
- HP Service Partition Is Not Created During Update (Itanium-based Systems Only)
- Update-UX Contains a Default-Installed Selection File
- Update-UX Creates Two Backup Configurations
- Security Considerations
- Standard HP-UX Bundle Considerations
- Online Diagnostics
- Offline Diagnostics
- The Next Step
- 4 Preparing to Install or Update to HP-UX 11i v2
- 5 Cold-Installing HP-UX 11i v2
- 6 Updating to HP-UX 11i v2
- 7 Installing HP Applications and Patches
- 8 Verifying System Install or Update
- A Data Collection Tables
- B Known Problems and Troubleshooting
- C Controlling Memory Utilization of VxFS 3.5 on HP-UX
- D Software Distribution Media
- HP-UX 11i v2 Core Software Bundles
- HP-UX 11i v2 Always-Installed Patch Bundles
- HP-UX 11i v2 Always-Installed Software Bundles
- HP-UX 11i v2 Always-Installed Network and Mass Storage Drivers
- HP-UX 11i v2 Default-Installed Software Bundles
- HP-UX 11i v2 Selectable Software Bundles
- HP-UX 11i v2 Selectable Network Drivers
Installing HP Applications and Patches
Installing HP-UX Applications
Chapter 7138
Option 2: Installing HP-UX Applications Using
Ignite-UX
You can install the Ignite-UX utilities to install HP-UX and applications
on other systems as follows:
Step 1. Mount the HP-UX 11i v2 DVD containing Ignite-UX and enter the
command:
/usr/sbin/swinstall -s /cdrom B5725AA
The mount point in the example is /
cdrom
.
Step 2. After installing the software, refer to the Ignite-UX release notes and
Ignite-UX Administration Guide to complete any post-install steps and
configuration.
After running an Ignite-UX install session, you have a working HP-UX
client system.
Refer to the Ignite-UX Administration Guide for detailed instructions on
how to install HP-UX applications. It is on the Instant Information DVD
and at the HP Technical Documentation Web site:
http://docs.hp.com/hpux/os/11iv2