HP-UX 11i Version 2 Installation and Update Guide, May 2005

Creating an HP Service Partition
Creating the HP Service Partition
Appendix A 147
The Additional Configuration Controls screen is displayed.
Step 10. Select HP Service Partition. Select 409600 (400 MB) from the list and
select
OK.
Step 11. In the Additional Configuration Controls screen, select
OK.
Step 12. In the /opt/ignite/bin/itool screen select
Go!
Your system partitions (EFI and HP Service Partition) have been
configured and Ignite-UX begins restoring your system data.
Step 13. If you backed up your user data using other backup software, restore this
data now following the vendor’s restore procedures.
Step 14. After your system and user data has been restored, run the idisk
command again to verify that the HP Service Partition was created and
the partition size is correct.