HP-UX 11i Version 2 Installation and Update Guide, May 2005

Updating to HP-UX 11i v2
Post-Update Tasks
Chapter 6124
Post-Update Tasks
After updating to HP-UX 11i v2, you might need to perform these
additional tasks to make your system fully functional:
1. Task 1: Configuring OE Applications.
2. Task 2: Creating an HP Service Partition.
Task 1: Configuring OE Applications
After updating to an HP-UX 11i v2 Operating Environment (OE), some
OE products need post-installation configuration to make them
functional. This need may be indicated by a message logged in
/var/adm/sw/swagent.log.
Refer to each product’s installation instructions for details. The location
of OE product documentation is listed in the HP-UX 11i v2 Release Notes,
available on the Instant Information DVD and at the HP Technical
Documentation Web site:
http://docs.hp.com
Task 2: Creating an HP Service Partition
Update-UX does not create or modify the HP Service Partition required
by some HP Offline Diagnostics tools. If you are updating from a system
that does not have an HP Service Partition, such as a system newly
updated from HP-UX 11i v1.6, you need to create the HP Service
Partition now. See Appendix A, “Creating an HP Service Partition,” on
page 139for instructions.