HP-UX 11i Version 2 Installation and Update Guide, May 2005

Updating to HP-UX 11i v2

Chapter 6112

Updating to HP-UX 11i v2

Updating your system using update-ux includes the following tasks:

1. Create a network depot so you can update other systems on the

network. See “Task 1: Creating a Network Depot (Optional)” on

page 113. If you are not creating a network depot, you can skip this

task.

2. Install the latest version of the update-ux command on your system.

See “Task 2: Installing the Latest Update-UX Bundle (Required)” on

page 114.

3. Use update-ux to update your system. Several examples are

provided to assist you with some of the most common scenarios for

using update-ux. See “Task 3: Using update-ux (Required)” on

page 116.

After updating to HP-UX 11i v2, you might need to perform these

additional tasks to make your system fully functional:

1. Configure OE Applications

2. Create an HP Service Partition (See Appendix A, “Creating an HP

Service Partition,” on page 139 for instructions.)