HP-UX 11i v2 Installation and Update Guide, September 2006

Cold-Installing HP-UX 11i v2
Cold-installing HP-UX 11i v2
Chapter 5 93
Network Data Collection Table
Table 5-2 provides HP-UX commands that you can use after the install to
confirm specific information.
Table 5-2 Network Data
Type of Data Your Specific Data
HP-UX Command to Confirm
Data After System is Up and
Running
Host Name uname -n
Host IP Address
nslookup name
Subnet Mask grep SUBNET_MASK
/etc/rc.config.d/netconf
Default Gateway IP
Address
grep ROUTE_GATEWAY
/etc/rc.config.d/netconf
Domain Name cat /etc/resolv.conf
DNS IP Address cat /etc/resolv.conf
NIS Domain Name grep NIS_DOMAIN
/etc/rc.config.d/namesvrs