HP-UX 11i v2 Installation and Update Guide, September 2006

System Requirements for Cold-Installing and Updating
System Requirements
Chapter 232
System Requirements
To cold-install or update HP-UX 11i v2, you must have the following:
• A supported system. See “Supported Servers” on page 36
• HP-UX 11i v2 OE and Application (AR) media (a two-DVD set)
• 512 MB memory, minimum
• 1 GB swap space, minimum
• 1 GB disk space to accommodate the EFI Boot Disk and the HP
Service Partition
NOTE If your system has less than 1 GB of memory, you may need to manually
set VxFS tunables for optimal performance after cold-installing or
updating to HP-UX 11i v2. For more information about these tunables,
see Appendix B, “Controlling Memory Utilization of VxFS 3.5 on HP-UX
11i v2,” on page 161.
System Firmware Requirements
The following minimum firmware requirements exist for systems
cold-installing and updating to the latest HP-UX 11i v2 (B.11.23) release.
• For HP 9000 PA-RISC Servers, you must update to the minimum
firmware revision before cold-installing or updating from HP-UX 11i
v1 (B.11.11) to the latest HP-UX 11i v2 (B.11.23) release.
• For HP Integrity Servers and Itanium-based systems, the firmware
shipped with the system meets the minimum firmware requirement
for the system for the latest HP-UX 11i v2 (B.11.23) release.
HP strongly recommends you review the minimum system firmware
matrix for HP-UX 11i v2 (B.11.23) systems at the HP Technical
Documentation Web site:
http://docs.hp.com/hpux/hw/index.html#System%20Firmware