HP-UX 11i v2 Installation and Update Guide, March 2006

Preparing to Cold-Install or Update to HP-UX 11i v2
Cold-Install Tasks
Chapter 4 71
Do not select more than one console device. HP-UX 11i v2 recognizes only
one device at a time. Choosing more than one device can result in the
appearance of system hang.
1. Decide what console you want to use.
Depending on your system configuration, HP-UX can use one of the
following devices as your system console:
• System Serial Port
• Management Processor (MP) Serial Port (if present)
• VGA device (if present)
2. Using the EFI menus, do the following:
• Select Boot option maintenance from the main Boot
Manager Menu.
• Select Select Active Console Output Devices.
• Select the correct output device and deselect others. On the HP
Integrity rx2600 and the HP Integrity rx5670 systems, the
Select
Active Console Output Devices
menu looks like this:
EFI Boot Maintenance Manager ver 1.10 [14.57]
Select the Console Output Device(s)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(PcAnsi)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(VtUtf8)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600
N81)/VenMsg(PcAnsi)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600
N81)/VenMsg(Vt100+)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600
N81)/VenMsg(VtUtf8)
* Acpi(HWP0002,700)/Pci(2|0)
Acpi(HWP0003,400)/Pci(0|0)
Save Settings to NVRAM
Exit