HP-UX 11i v2 Installation and Update Guide, June 2007

System Requirements for Cold-Installing and Updating
Supported Servers
Chapter 236
Supported Servers
HP-UX 11i v2 supports only the 64-bit version of the HP-UX kernel. This
release of HP-UX 11i v2 release fully supports the following HP 9000
servers and HP Integrity servers, as well as the new PA-8900 processor.
For additional information about these servers go to the Web site:
http://docs.hp.com/hpux/hw
NOTE HP-UX 11i v2 is not supported on PA-RISC Workstations. HP
recommends that PA-RISC Workstation customers use HP-UX 11i v1.
The HP-UX 11i v2 May 2005 release was the last release supported on
the Itanium-based zx2000 and zx6000 workstations. These workstations
have been discontinued as of September 2004.
PA-RISC Servers
• HP 9000 rp24x0 and rp34x0 series
• HP 9000 rp44x0 and rp54x0 series
• HP 9000 rp74x0 and rp84x0 series
• HP rp7440 server (8 sockets) with PA8900 processors and sx2000
chipset
• HP rp8440 server (16 sockets) with PA8900 processors and sx2000
chipset
• HP 9000 Superdome server
• 64-bit A-Class, L-Class, and N-Class servers
Itanium-based Servers
• HP Integrity rx16x0 server
• HP Integrity cx2600 server
• HP Integrity rx26x0 server
• HP Integrity rx3600/rx6600 servers
• HP Integrity rx4640 server
• HP Integrity rx5670 server