HP-UX 11i v2 Installation and Update Guide, December 2007

Cold-Installing HP-UX 11i v2 Using Media
Cold-installing HP-UX 11i v2 from Media
Chapter 5 95
Step 3. From the User Interface and Media Options window, choose the
degree of customizing needed to configure the installation. Mark your
choices and select
OK.
• Select from one of the three choices shown in Source Location
Options:
— Media only installation is the default setting for installing
from a DVD.
— Media with network enabled is recommended when you want
basic networking enabled during installation so you can save the
system install log and system configuration on the Ignite-UX
server. If you select this option, Ignite-UX will request network
settings so that the server may be reached. You may use DHCP
to configure networking if a server is available.For more help on
using this option, refer to the Ignite-UX Administration Guide.
— Ignite-UX server based installation is recommended if you
have an Ignite-UX server configured on your network and you
want to supply custom configurations during the installation.
• Select from one of the three choices shown in User Interface
Options:
— Guided Installation provides limited system configuration and
is expected to be deprecated in a future release.
— Advanced Installation enables you to accept all the default
installation parameters or fully customize your system such as
configuring multiple disks and adjusting file system sizes. HP
recommends choosing the Advanced Installation option to
configure your installation.
— No User Interface is recommended if you want to accept all the
default installation parameters and you do not need to verify the
configuration using the user interface.
The remaining sections take you through the Advanced Installation
option. For more help on using the
Advanced Installation option, refer to
the Ignite-UX Administration Guide.