HP-UX 11i v2 Installation and Update Guide, December 2007

Choosing an Installation Method
Security Considerations
Chapter 358
4. Do one of the following:
• Manually update the system configuration: Edit the
/etc/inetd.conf file by uncommenting (remove the #) the
following line:
#auth stream tcp6 wait bin /usr/lbin/identd identd
Force inetd to reread the configuration by running the following
command:
# inetd -c
• Use HP-UX Bastille to update the configuration: Revert to the
previous HP-UX Bastille configuration; then apply the new
HP-UX Bastille configuration.
# bastille -r
# bastille -b [-f <location of config file> ]
Configuring HP-UX Bastille Sec10Host
To configure the HP-UX Bastille Sec10 Host, refer to the Securing
Serviceguard document at:
http://docs.hp.com/
CAUTION When reverting to the previous HP-UX Bastille configuration, note these
precautions:
• Security configuration changes will be undone temporarily.
• Other manual configuration changes or additional software installed
since HP-UX Bastille was initially run may result in HP-UX Bastille
requiring a manual merge of configuration settings.