HP-UX 11i v2 Installation and Update Guide, December 2005

Known Problems and Troubleshooting
Known Install and Update Problems
Appendix B148
Known Install and Update Problems
Table B-1 describes problems known to occur in the HP-UX 11i v2
release.
Table B-1 Known Install and Update Problems
Problem Description/Action
Error When Updating
to the HP-UX 11i v2
December 2005
Operating
Environments
If you are updating your HP PA-RISC server to the HP-UX
11i v2 December 2005 Operating Environments, you may
encounter the following error messages in the swinstall.log
during the update process:
ERROR: [120286] Could not apply the software
selection "VMGuestLib" because it refers to a bundle
or to a product, subproduct or fileset within a
bundle but no compatible bundles meeting the
specification were found.
ERROR: [120286] Could not apply the software
selection "VMProvider"because it refers to a bundle
or to a product, subproduct or fileset within a
bundle but no compatible bundles meeting the
specification were found.".
What To Do
The products, VMGuestLib and VMProvider, can only be
installed on HP Integrity Servers. Before you update your HP
PA-RISC server, do one of the following:
• Install Update-UX from the HP-UX 11iv2 December 2005
OE. Remove the products listed above from the
/usr/lib/sw/update-ux.selections file, or
• Create an update-ux selections file that excludes the
products listed above. Make sure to use the -f option as
shown in the example syntax below:
update-ux -s <depot> -f <new_selections_file>
HPUX11i-<OE_Type>