HP-UX 11i v2 Installation and Update Guide, December 2005

Creating an HP Service Partition
Creating the HP Service Partition
Appendix A 143
• To save a system archive to tape:
make_tape_recovery -a /dev/rmt/0mn -A
Step 3. Reboot your system.
If you created a system archive using the make_tape_recovery
command, insert your HP-UX 11i v2 DVD into the DVD drive before
resetting your system.
Step 4. Depending on which method you used to create your system archive,
choose the appropriate boot method:
• make_net_recovery method: Select the appropriate network EFI
boot option.
• make_tape_recovery method: Select the appropriate DVD boot
option.
NOTE Refer to the Ignite-UX Administration Guide for more details and
information about the appropriate boot methods.
Step 5. Enter the appropriate keyboard device for your system.
The Welcome to Ignite-UX! screen appears.
Step 6. Use the Tab key, select
Advanced Options.
The User Interface and Media Options screen appears.
Step 7. From the list of User Interface Options, select Advanced Installation,
then select
OK.
The /opt/ignite/bin/itool screen appears.
Step 8. From the Basic tab, select Additional.
The Additional Configuration Controls screen appears. This screen
includes a list of current partitions and their sizes (in KB).
Step 9. Select EFI Boot Partition.
A popup window appears listing partition size options (in KB) that you
can choose from. Select 512000 (500 MB) from the list and select
OK.