HP-UX 11i v2 Installation and Update Guide, December 2005

Updating to HP-UX 11i v2

Chapter 6 121

Updating Selectable Software

To update to HP-UX 11i v2 and specify additional selectable bundles

such as Software Package Builder on the command line, follow these

steps:

Step 1. If you want to install the HP-UX 11i v2 Foundation Operating

Environment bundles listed in Appendix D, “HP-UX 11i v2 Software

Bundles,” on page 169, plus the SwPkgBuilder Software Package Builder

bundle, enter:

/usr/sbin/update-ux -s /dvdrom HPUX11-OE SwPkgBuilder

If you only want to update your system with a selectable software

bundle, enter:

/usr/sbin/update-ux -s /dvdrom SwPkgBuilder

Step 2. Complete any configuration for HP software explained in the HP-UX 11i

v2 Release Notes available on the Instant Information DVD and at

http://docs.hp.com/hpux/os/11iv2

Update Using match_target

The following command using the match_target option installs the

entire HPUX11i-OE bundle, including all OS, networking, CDE, and

diagnostic bundles and any software selected by match_target. The

software you want to install might not come from a bundle.