DUMPAAEnable Version B.11.23.0609 Release Notes

Installing DUMPAAEnable Version B.11.23.0609

Step 4. To verify whether the DumpAASupport software is installed, enter the following

command at the HP-UX prompt:

# swlist -l bundle DumpAASupport

If the installation is successful, the following output is displayed:

DumpAASupport B.11.23.01 Crashdump support for Active Active

devices

Removing DUMPAAEnable Version B.11.23.0609

To remove the Dump Support product, use the swremove command:

# swremove -x autoreboot=true DUMPAAEnable

NOTE The swremove command removes the product and reboots the system, leaving

the bundle wrapper (DumpAASupport) and the kernel patches on the system.

HP recommends that you do not remove the kernel patches included with the

product bundle.

For more information on managing patches on your system, see the HP-UX Patch

Management user guide. This document is available on the Support Plus media as well as on

the Hewlett-Packard documentation web site http://docs.hp.com/en/oshpux11iv2.html.