Using the HP DTC Manager/UX

137
11
Resetting DTC configurations
This chapter provides information about when and how to reset DTC configurations.
DTC configurations are reset whenever the configuration information is downloaded
to the DTC (each time the DTC is rebooted, for example). Topics covered include:
• when you need to download the DTCs configuration
• why you sometimes need to download the DTC's configuration from the
DTC Manager/UX to the DTC
• how to download the DTCs configuration.
When to download the configuration
Most configuration changes are made automatically (dynamically). However,
certain parameters cannot be dynamically configured. In this instance you must
download the new configuration to the DTC in order for these changes to take effect.
The parameters that require resetting the DTC are:
• DTC node name
• DTC IP address
• any of the TCP timers (if you modify the initial timer configuration)
• any of the following SNMP parameters:
• contact name
• sys name
• sys location
• SNMP enable authentication traps
• trap destination IP address
• any of the DTC management protocol parameters (if you modify the initial
management configuration)