Using the HP DTC 16RX Manager

94
Copying and pasting a single port configuration
12
Copying and pasting a single port configuration
The destination DTC port can be on the same DTC or on another DTC.
1 At the system prompt, type:
rdtcmodify dtcname
The DTC Rear Panel Configuration screen appears.
2 In the Board field enter B or b. Use the arrow key to go to the Port field and
enter the required port number.
3 Press the Action Menu (F5) function key and then select Copy.
4 A confirmation message is displayed showing that the data was copied.
5 Press the space bar. You return to the Rear Panel Configuration screen.
Note If you are copying and pasting configurations on the same DTC, skip steps 6 and 7
and go directly to step 8.
6 To exit, press the Exit Task (F8) function key. This returns you to the system
prompt.
7 At the system prompt, type:
rdtcmodify other_dtcname
The DTC Rear Panel Configuration screen appears.
8 In the Board field enter B or b. Use the arrow key to go to the Port field and
enter the required port number.
9 Press the Action Menu (F5) function key and then select Paste.
A confirmation message is displayed showing that the data was pasted.
10 Press the space bar. You return to the Rear Panel Configuration screen.
11 Press the Exit Task (F8) key to exit. You return to the system prompt.
rdtcmodify dtcname
or
rdtcadd dtcname dtc_IP_address
DTC backplane
Board = B or b, Port = #
Configure
parameters
port
Enable
port
options
Save
as user
default
Copy
Paste
Change
port type