Using the HP DTC 16RX Manager

86
Configuring port parameters
11
Modem Behavior If you have selected a direct connect port, modem behavior is not used and should
be set to None. The default is None. If you have selected a port on a modem port
group, select modem behavior by pressing the Help (F1) function key. A list is
displayed. Highlight your choice and press Return or the Select Item (F4) function
key.
The DTC checks device modem signals and sets up its own modem signals. You
may want to enable the automatic connection port option for this port. If enabled,
the DTC will establish a connection to the Default Destination as soon as it senses
modem signal activity, see “Default Destination (IP Address or Internet Services
name)” on page 87, and see “Enable Automatic Connection” on page 79.
Terminal Modem Ports
None—use for a directly connected terminal.
Standard DCE—user for a terminal connected to the DTC port via a
modem/multiplexer.
DCE high—use for a terminal connected to the DTC port via a
modem/multiplexer, and where you need an indefinite time-out before pressing
Return to connect to the DTC user interface.
DTE—use when the connection to the terminal is initiated by the host.
Printer Modem Ports
None—use for a directly connected printer.
Standard DCE or DCE high—use for a modem connected printer, where a link is
made at the device.
DTE—use when the connection to the terminal is initiated by the host.
Host Modem Ports
None—use when connecting to hosts that do not support modem signals.
Standard DCE—use for a host connected to the DTC port via a
modem/multiplexer.
DCE high—do not use for host port.
DTE—use when connecting to hosts that support modem connection.