Using the HP DTC 16RX Manager

Changing a port group

Figure 11. Changed Port Group in Rear Panel Configuration Screen

5 You must perform a disruptive reset the DTC to modify the port group type.

Press the Exit Task function key to leave the DTC Manager menu-driven user

interface. You are asked several questions to confirm your configuration. To

activate your changes you can either:

• Type y to the question: Do you want to reset the DTC 16RX now?

• Type the following command later at the prompt:

rdtcreset dtcname

Note The port group type configured in DTC Manager must match the hardware

configuration of the DTC. Otherwise the configuration cannot be downloaded. If, for

example, you have connected an MDP to the left hand connector in the DTC, you

must set the ports 0 to 7 port group type to MODEM.