Using the HP DTC 16RX Manager

63
Configuring SNMP/MIB data parameters
8
1 Type the following command at the system prompt:
rdtcmodify <claudia>
The DTC Rear Panel Configuration screen appears.
2 Enter L or l in the board field of the Rear Panel Configuration screen.
3 Press the Action Menu (F5) function key for a list of action options.
4 Select Configure SNMP/MIB Data Parameters and press the Select Action
(F4) function key. Enter the field values, referring to the online help for
guidance.
5 When you have finished entering values, press the Perform Task (F4) function
key. You return to the Rear Panel Configuration screen.
6 You must perform a disruptive reset the DTC to modify the SNMP parameters.
Press the Exit Task function key to leave the DTC Manager menu-driven user
interface. You are asked several questions to confirm your configuration. To
activate your changes you can either:
• Type y to the question: Do you want to reset the DTC 16RX now?
or
• Type the following command later at the prompt:
rdtcreset <claudia>
The SNMP/MIB data configuration parameters
Contact Name Enter up to 255 ASCII characters. Contact the SNMP manager of your network to
find the name of the contact person to enter for this DTC. This optional field can
include information on how to contact the person as well as a name.
Sys Name Enter up to 255 ASCII characters if you want to use this optional field. Contact the
SNMP manager of your network to find the system name you should enter here.
This name will be used to identify the DTC as an SNMP node and is by convention
the same as the DTC node name.
Sys Location Enter up to 255 ASCII characters to specify the physical location of the DTC. This
is an optional field.
SNMP Enable
Authentication Traps
Set this optional field to Disabled or Enabled. Enabled means that the SNMP
process agent of the DTC can generate authentication failure traps.
The default setting is Enabled.